Marmitek X-10 Manuel d'utilisateur

LW12N WALL LAMMODULELW12IN WALL LAMPMODULE20486/20120530 • LW12TMIN WALL LAMP MODULEALL RIGHTS RESERVED MARMITEK®USER MANUAL

Resetting the LW12When leaving the factory, the LW12 is set to the default address A1en does not respond to the optional functions All Lights On/All L

FREQENTLY ASKED QUESTIONSWhat is the reason for modules to switch on/off spontaneously?It is possible that a Marmitek X-10 System is installed at one

If your lamp doesn’t work:• Does the light work if you connect it directly to the mains?• Is the module connected to a surge protector? A surge prot

DECLARATION OF CONFORMITYHereby, Marmitek BV, declares that this LW12 is in compliance with the essentialrequirements and other relevant provisions of

2 © MARMITEK

INSTALLATION INSTRUCTIONS FOR MARMITEKX-10 IN-WALL DIMMER MODULE LW12™SAFETY WARNINGS• The wiring of your electrical installation is live (230 V) and

How does Marmitek X-10 work?Marmitek X-10 components use the existing mains wiring tocommunicate (using Marmitek X-10 signals). You can build a comple

Signal Range Range of Marmitek X-10 signals over the Power Line and howto increase the range.The Marmitek X-10 System is based on power line communic

Known devices which can cause attenuation are:PC MonitorsPCs with heavy internal power suppliesOld TelevisionsCopiersFluorescent LightsGas Discharge L

INTRODUCTIONCongratulations on your purchase of the LW12.• The MicroModule can be installed behind conventional wallswitches or into wall outlets bec

INSTALLATION• Switch off appropriate mains fuse and master switch!• Where present, take the wall switch out of the wall box.• Disconnect all wires

Programming the address and the optional functions AllLights On/All Lights Off/All Units Off:Unlike most Marmitek X-10 Modules the LW12 does not have