Marmitek MS9970 Manuel d'utilisateur télécharger pdf (Page 22)

22 MARMITEK

5.9 ERASING OF A REGISTERED SENSOR

5.10 ERASING OF ALL SENSORS

In case it is required, you can reset the base station to the factory default settings. However, your PIN and option settings

remain the same. Every time you press a key you hear a short confirmation beep.

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8)

3. Press key number 0

4. Press ENTER

5. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

If necessary a sensor can be erased from the memory of the base station (e.g. code changed when batteries were

changed). When you want to re-register a specific sensor with the same zone, you have to follow the instructions under 5.1

(register sensors on a pre-defined free zone).

To erase a registered sensor:

Every time you press a key you hear a short confirmation beep.

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8)

3. Press key number 8

4. Press ENTER

Enter the required zone (1…16, e.g. press 2 for zone 2, press 1 + 5 for zone 15):

6. Press ENTER

7. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Pas de commentaire

Marmitek MS9970 Manuel d'utilisateur Page 22