Marmitek X-10 Manuel d'utilisateur télécharger pdf (Page 4)

How does Marmitek X-10 work?

Marmitek X-10 components use the existing mains wiring to

communicate (using Marmitek X-10 signals). You can build a complete

system using the three different kind of components of the Marmitek

X-10 System:

1. Modules:

These components will receive Marmitek X-10 signals and will switch

or dim the attached lamp or appliance.

2. Controllers:

These components will transmit Marmitek X-10 signals and thus will

control the Modules.

3. Transmitters:

Wireless components like remotes. The signals of these components

will be received by a controller with transceiver functionality (IRRF 7243,

TM13 or console of a Marmitek Security System).

The Transceiver will translate the signals into Marmitek X-10 signals on

the power line.

Addresses

Up to a maximum of 256 different addresses can be preset. These are

subdivided into a so-called HouseCode (A to P incl.) and a UnitCode (1

to 16 incl.). The HouseCode can also be set on the controllers, so that

the controllers and modules become part of the same system. The

address can be set either using code dials or by pressing buttons,

depending on the type of module.

The Marmitek X-10 System uses standard commands, which control all

units with the same HouseCode at the same time (e.g. all lights on, all

off, etc.).

4 © MARMITEK

1 2 3 4 5 6 7 8 9 ... 13 14

Pas de commentaire

Marmitek X-10 Manuel d'utilisateur Page 4