Marmitek X-10 Manuel d'utilisateur télécharger pdf (Page 7)

INTRODUCTION

Congratulations on your purchase of the LW12.

• The MicroModule can be installed behind conventional wall

switches or into wall outlets because of the extreme small size of

the MicroModule (Minimum built-in depth 40 mm, advised 50

mm). The MicroModule is also ideal for installation into light fixtures

or for use in areas with limited space such as rooms with lowered

ceilings.

• Universal compatibility: No limitation in choosing brand, colour or

type of any wall switches and outlets. The LW12 can be used to

switch and dim 230V light bulbs, 230V halogen lamps and low-

voltage halogen lamps with transformers ranging from 60 to 250

watts/230 volts.

This module can be activated using a momentary switch connected

to it or using Marmitek X-10 PLC signals. It can be operated using the

following Marmitek X-10 signals: ON, Off, DIM, BRIGHT and the

optional Marmitek X-10 commands All Lights On/All Lights Off/All

Units Off if these are programmed. The unit will accept a momentary

switch. The input for the switch is connected to the phase (brown

wire, 230V), the output of the switch is connected to input "K" of

the LW12 MicroModule. See figure A.

No Neutral (blue wire) has to be connected to the LW12

MicroModule, which means it can be easily used instead of a normal

switch, without additional wiring. The module is equipped with

softstart, softdim and a memory setting for the last dim level. When

power has been interrupted, the module will be in the OFF position.

The LW12 uses 1-way X-10 communication.

7LW12

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Marmitek X-10 Manuel d'utilisateur Page 7