Marmitek X-10 Manuel d'utilisateur télécharger pdf (Page 9)

Programming the address and the optional functions All

Lights On/All Lights Off/All Units Off:

Unlike most Marmitek X-10 Modules the LW12 does not have code

wheels.

When leaving the factory, the LW12 is set to the default address A1

en does not respond to the optional functions All Lights On/All Lights

Off/All Units Off. To change the address and the settings for the All

Lights On/All Lights Off/All Units Off functions, the module needs to

be set to the program mode.

Activating the program mode can be done in 2 ways:

1. By transmitting On / Off commands of the set address in quick

succession (e.g. if the address is B2: B2 ON, B2 OFF, B2 ON, etc.) After

the LW12 has changed state 5 times, with no more than 1.5 seconds

between changes, the LW12 will no longer respond, which means the

module is set to the program mode.

2. By quickly pressing/switching the momentary switch connected to

the module. After the LW12 has changed state 5 times, with no more

than 1.5 seconds between changes, the LW12 will no longer respond,

which means the module is set to the program mode. Once in

Program Mode the new address can be set by sending an "Address"

or "Address On" (e.g. B2 ON) or "Address Off" command for the

new address code twice (using any Marmitek X-10 controller). If you

want to change the code again, just send the new ‘Address ON’ or

‘Address OFF’ commando twice. To set the unit to respond to "All

Lights On" and/or "All Lights Off" and/or "All Units Off" just send

these commands twice for the new address code (using any X-10

controller).

Please note: The "All Lights On/All Lights Off /All Units Off" options

can be disabled by setting a new address or by returning to the

Default Setting.

9LW12

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Marmitek X-10 Manuel d'utilisateur Page 9