Marmitek SC9000 Guide de l'utilisateur télécharger pdf (Page 30)

EXTRA OPTIONS

HAIBRAIN

9.7 Deregistering a Motion Detector

1. To access the menu, press the menu  or menu  button. The display will now read ‘ENTER PIN’.

2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear

on the display.

3. When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.

4. Press OK.

5. Enter the number of the zone you want to erase on the number pad and press CLEAR.

6. You are asked to confirm CLEAR ZONE 1. YES 2. NO.

7. Press 1 to erase the zone. The zone number is shown on the display.

8. Press CLEAR again to quit the menu.

☺ Zones 31 and 32 cannot be erased.

10.Advanced Home Automation functions

In chapter 7 you learnt how

to use the Haibrain X-10 Home Automation options of your security system. But there is a lot more.

Haibrain not only has the Plug & Play modules described, but a large number of built-in switches, sun blind switches, remote

controls and special modules which can be used in combination with your security system. With these modules you can control

nearly everything that is electrically powered in your home via your security system. See www.Haibrain.com (Product group Home

Automation) for more information.

Your system has a few extra standard functio

ns that use the Haibrain X-10 system:

10.1 Checking the status of the security system

Set a Haibrain

X-10 module to address B1. This Home Automation module is now automatically switched on as soon as the

security system is activated. When the system is disarmed, the module is also switched off. Example: You can connect a table lamp

to this X-10 module. If the system is activated, this lamp is always turned on. This means you can instantly see if the system is

activated when you are outside.

10.2 Installing an extra sire

n (Haibrain PH7208, art. no. 08929)

Set the siren PH7208 to address A1.

To avoid false alarms, the system waits 20 seconds after triggering the alarm before the siren

is activated. The siren will give a piercing two-tone signal for 4 minutes. After these 4 minutes the siren is automatically switched

off (or sooner if the alarm is switched off).

ATTENTION: When using a Haibrain security system, the extra sirens will always work in case of an alarm, even when the system

is set to silent alarm! The Siren PH7208 is meant for indoor use and can be plugged into any wall socket.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Marmitek SC9000 Guide de l'utilisateur Page 30